Download  Print this page

Throttle Grip And Cables; Throttle Grip Free Play Inspection; Throttle Grip Free Play; Adjustment - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Throttle Grip and Cables
FUEL SYSTEM 2-7
Throttle Grip Free Play Inspection
. Check that the throttle grip moves smoothly from fullopen
to close, and the throttle closes quickly and completely in
all steering positions by the return spring.
*If the throttle grip does not return properly, check the throt-
tle cable routing, grip free play, and cable damage. Then
lubricate the throttle cable.
.
Run the engine at the idle speed, and turn the handlebar
all the way to the right and left to ensure that the idle speed
does not change.
*If the idle speed increase, check the throttle cable free
play and the cable routing.
.Inspect
the free play [A] of the throttle grip.
Throttle Grip Free Play
Standard:
2
-
3 mm (0.08- 0.12 in.)
*If the free play is incorrect, adjust the throttle
cable.
Throttle Grip Free Play Adjustment
. Loosen the locknut [A].
.
Turn the adjuster [8] until the proper amount of throttle
grip free play is obtained.
.
Tighten the locknut securely against the adjuster.
* If the free play cannot be adjusted with the upper adjuster,
use the adjusters at the center of the cables.
.
Loosen the locknut, and screw the adjuster near the upper
end of the accelerator cable all the way in.
.
Tighten the locknut securely.
.
Remove the fuel tank (see Fuel Tank Removal).
.
Loosen the locknuts at the center of the acceleration ca-
ble.
.
Screw both throttle cable adjuster to give the throttle grip
plenty of play.
.
With the throttle grip completely closed, turn out the de-
celerator cable adjuster [A] until the inner cable just be-
comes tight.
.
Tighten the decelerator cable locknut [8] securely.
.
Turn the accelerator cable adjuster [A] until the correct
throttle grip free play is obtained.
.
Tighten the accelerator cable locknut [8] securely.
* If the proper amount of free play can not be obtained in
the adjustable range of the adjuster, use the adjuster at
the upper end of the accelerator cable
again.
GC040112S1
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: