Download  Print this page

Advertisement

Ignition System
Crankshaft Sensor Peak Voltage Inspection
• Measure the crankshaft sensor's peak voltage as follows:
ORemove the right side cover.
ODisconnect the crankshaft sensor connector [A].
NOTE
o
To obtain
a
correct measurement, the leads
as
well
as
the lead connections must be correct. Take the volt-
age measurement
with
the proper cylinder compres-
sion (with the spark plugs in the cylinder head). Without
proper compression,
a
correct measurement cannot be
obtained.
aSet the range of the tester to DC 10 V.
OConnect the peak voltage adapter [A] to the tester, and
connect the terminals of the adapter to the terminals of
the crankshaft sensor connector [8].
Special Tool - Kawasaki Hand Tester: 57001-1394
Peak Voltage Adapter: 57001-1415
Type: KEK-54-9-B
ELECTRICAL SYSTEM 14-39
Connect:
Adapter positive (+) terminal _
yellow lead
terminal [A]
Adapter negative (-) terminal _
black/white lead
terminal [B)
OCrank the starter motor for several seconds and read the
highest value on the tester.
Crankshaft Sensor Peak Voltage
Standard:
2.4 V or more
*
If the peak voltage is lower than the standard, inspect the
crankshaft sensor.
A
B

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: