Download  Print this page

Advertisement

14-36 ELECTRICAL SYSTEM
Ignition System
• To examine the condition of the igniter, connect the igniter
checker to the igniter as shown.
Special Tools -Igniter Checker Set: 57001-1378 [A]
Wiring Harness Adapter, #14: 57001-1427
[B]
Wiring Harness Adapter, #2: 57001-1382 [C]
Ie Igniter [D]
Battery [E]
aSet the select knob to position "AM.
NOTE
OFo/Jow the instructions in the manufacturer's operation
manual for the proper procedure for operating the ig-
niter checker.
o
The igniter checker can perform inspections by simu-
lating the following dynamic characteristics: the igniter
response in relation to the engine speed, interlock cir-
cuit signals, tachometer signals, and engine overspeed
limiter signals.
o
The igniter checker cannot be used for inspecting the
conditions of the COl unit.
*If the igniter is defective, replace it.
IC Igniter Operating Voltage Check
• Set the range ofthe hand tester to DC25 V, and connect
its terminals to the brown/white [6] and the black/yellow
[C] terminals in the igniter connector [AJ at the main har-
ness.
Special Tool- Kawasaki Hand Tester: 57001·1394
Connect:
Tester positive (+) terminal..........
brown/white lead
terminal
Tester negative (-) terminal _
black/yellow lead
terminal
• Turn the ignition switch ON.
• Read the voltage on the tester.
Ie
Igniter Operating Voltage
Standard:
battery voltage
* If there is no voltage or if it is low, inspect the battery
voltage, ignition switch, and the ignition fuse.
Ignition Coil Primary Side Peak Voltage Inspection
• Remove the following parts:
Seat (see Frame chapter).
Fuel Tank (see Fuel System chapter).
."0013OS, C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: