Download  Print this page

Crankshaft Sensor Inspection; Ignition Coil Removal; Ignition Coil Installation - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Ignition System
Crankshaft Sensor Inspection
• Remove the right side cover.
• Disconnect the crankshaft sensor lead connector.
eSet the hand tester to the x 100
n
range, and measure
the resistance between the female connector's black lead
and the yellow lead terminal
Special Tool - Hand Tester: 57001·1394
*11 the reading is out of standard, replace the crankshaft
sensor.
Crankshaft Sensor Resistance
Standard:
380 - 560
0
• Set the hand tester to the maximum range and measure
the resistance between the frame ground and the female
connector's black wire, yellow wire terminals.
*If
the reading is not infinity (00), replace the crankshaft
sensor.
Ignition Coil Removal
• Remove the fuel tank (see Fuel tank Removal).
• Disconnect the secondary lead from the spark plug.
e Disconnect the primary lead from the ignition coil.
e Remove the mounting nuts and take out the ignition coil
[A).
e Disconnect the secondary lead from the spark plug cap.
Ignition Coil Installation
eTighten the ground terminal [A] with the front mounting
nut for the #3 and #4 ignition coils.
e Connect the primary wire to the primary coil tenninal as
follows:
Black wire
ignition coil for #1, #4 cylinder [B)
Green wire
ignition coil for #2, #3 cylinder [C)
Red wire
ignition coil for #1 - #4 cylinder
ELECTRICAL SYSTEM 14-33

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: