Download  Print this page

Advertisement

Steering
STEERING 12-7
.
Replace the lower bearing with a new one.
.Install
the grease seal on the steering stem, and drive the
lower bearing [A] applied the grease onto the stem.
Special Tools
-
Steering
Stem Bearing
Driver:
57001-137
[A]
Steering
Stem
Bearing
Driver
Adapter,
<1>34.5:57001-1074
[B]
.
Apply grease to the upper bearing, and install it in the
head pipe.
.Insert
the stem shaft through the head pipe and the bear-
ings. Then, while holding the stem base from the bottom,
install the Q-ring [A] on the shaft.
.Install
the stem cap [8] and hand-tighten the locknuts [C].
NOTE
o
To install the stem locknut, face its stepped side down.
.Install
the stem head.
. Install the washer, and lightly tighten the stem head nut.
.
Allow the bearings to settle.
OTorque the stem locknut to 39 N.m (4.0 kgf.m, 29 ft.lb).
Special Tool
-
Steering Stem Nut Wrench: 57001-1100 [A]
22.2 kg
OCheck whether the stem turns smoothly without free play.
If it feels tight or has free play, the bearings could be dam-
aged.
OGradually
loosen the stem locknut until the stem turns
easily.
ORetighten the stem locknut and stop when the stem starts
to turn hard.
Torque
-
Steering
Stem Locknut:
4.9 N.m (0.5 kgf.m, 43
in.lb)
GN050604S 1 C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: