Remove the stem locknuts [A].
. Removethe stem cap .
Steering Stem Nut Wrench: 57001-1100 [B]
Hold the stem base, remove the O-ring [A], and take out
the stem .
Remove the upper bearing [C].
Remove the bearing outer race.
Head Pipe Outer Race Remover ID > 37 mm:
Remove the lower bearing [A] and grease seal.
Bearing Puller: 57001-158 [B]
Bearing Puller Adapter:
Steering Stem and Stem Bearing Installation
Replace the bearing outer races with new ones.
Apply grease to the outer race, and drive both upper and
lower races into the head pipe at the same time.
Head Pipe Outer Race Press Shaft:
Head Pipe Outer Race Driver, cp46.5: 57001
Head Pipe Outer Race Driver, cp51.5: 57001