Download  Print this page

Steering Stem And Stem Bearing Removal - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Steering
STEERING 12-5
.
Tighten the following:
Torque
-
Steering
Stem Head Nut: 49 N.m (5.0 kgf.m, 36
ft.lb)
Front Fork Lower Clamp Bolts: 20 N.m (2.0 kgf.m,
14 ft.lb)
NOTE
o Tighten
the two clamp bolts alternately two times to en-
sure
even
tightening torque.
o Tighten the top plug before tightening the upper fork
clamp bolt.
.
Reinspect the steering.
*If it still feels tight or loose, inspect every part of the steer-
ing.
.Install the removed parts.
Steering Stem and Stem Bearing Removal
. Remove:
Fuel Tank (see Fuel Tank Removal)
Front Wheel (see Wheel/Tires chapter)
Front Fender (see Frame chapter)
.
Disconnect:
Ignition Switch Connector [A]
. Loosen:
Front Fork Clamp Bolts [B]
.
Remove:
Harness and Cable Holder Bolts [C]
Handlebar Clamps [D]
Handlebar [E]
.
Remove the stem head nut [F] and washer.
.
Remove the front fork [G] (see Suspension chapter).
.
Remove the stem head [H].
.
Remove the brake hose joint mounting bolts [A].

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: