Download  Print this page

Tie Rod/rocker Arm; Tie Rod Removal; Tie Rod Installation; Rocker Arm Removal - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Tie Rod/Rocker Arm
SUSPENSION 11-15
Tie Rod Removal
.
Set the motorcycle on its center stand and raise the rear
wheel.
.
Squeeze the brake lever slowly and hold it with a band
[A].
A
WARNING
Be sure
to hold the front brake when removing the
shock absorber, or the motorcycle may tall over. It
could cause an accident and injury.
.
Remove:
Upper Tie Rod Bolt [A]
Lower Tie Rod Bolt [B]
Tie Rods [C]
Tie Rod
Installation
.
Apply grease to the inside of the needle bearings, sleeve
and the grease seals.
.Install the tie-rods so that the chamfered side faces the
bolt and nut.
.
Tighten the tie rod nuts.
Torque
-
Tie Rod Nuts: 59 N.m (6.0 kgf.m, 43 ft.lb)
Rocker Arm Removal
.
Set the motorcycle on its center stand and raise the rear
wheel.
.
Squeeze the brake lever slowly and hold it with a band.
A
WARNING
Be sure to hold the front brake when removing the
shock absorber, or the motorcycle may tall over. It
could cause an accident and injury.
.
Remove:
Lower Rear Shock Absorber Bolt [A]
Lower Tie Rod Bolt [B]
Center Stand Spring [C]
Rocker Arm Bolt [D]
Rocker Arm [E]

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: