Download  Print this page

Advertisement

10-16 BRAKES
Brake
Discs
Br:3ke
Disc
W:3rp
.
Set the motorcycle up on its center stand for rear disc
measurement.
.
Set up a dial gauge perpendicularly
against the disc [A]
as shown and measure disc runout. While turning [B] the
wheel
by
hand.
NOTE
o
In the case of the front disc, place a suitable base under
the engine to raise the front wheel, and turn the handle-
bar fully to either right or left. The measurement should
be taken approximately 10 mm (0.4 in.) inside from the
outer perimeter.
Special Tool-
Jack: 57001-1238
.
Slowly turn the wheel by hand and measure the disc
runout.
*Replace
the disc if it has worn past the service limit.
Brake Disc Runout
Standard:
0.2 mm (0.008 in.) or less
Service Limit:
0.3 mm (0.012 in.)

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: