Download  Print this page

Coupling Bearing Installation; Coupling Bearing Inspection And Lubrication - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

9-14 FINAL DRIVE
Sprocket/Sprocket
Coupling
Coupling
Bearing
Installation
.
Replace the bearing with a new one.
.
Press in the bearing until it is bottomed.
Special
Tool- Bearing Driver Set: 57001-1129 [A]
. Pack
the bearing with high temperature grease.
.
Replace the circlip with a new one.
Special Tool
-
Inside Circlip Pliers: 57001-143
.
Replace the grease seal with a new one.
.
Press in the grease seal so that the seal surface is flush
with the end of the hole.
OApply high temperature grease to the grease seal lips.
Special Tool-
Bearing Driver Set: 57001-1129 [A]
Coupling Bearing Inspection
and Lubrication
Since the coupling bearing is made to extremely close
tolerances, the clearance can not normally be measured.
NOTE
o It is not necessary to remove the coupling bearing for
inspection and lubrication. If the bearing is removed, it
will
need to be replaced with a new one.
.
Spin
[A] it by hand to check its condition.
* If it is noisy, does not spin smoothly, or has any rough
spots, it must be replaced.
.
Pack the bearing with good quality bearing grease. Turn
the bearing around by hand a few times to make sure the
grease is distributed uniformly inside the bearing.
GI14010151
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: