9-8 FINAL DRIVE
Screw the pin holder until it touches the chain pin.
Be sure that the cutting pin hits center of the chain pin.
Screw the handlebar [A] into body.
Turn the pin holder with the wrench [B] clockwise to the
extract chain pin.
. Engage the new drive chain to the old drive chain and pull
the end of the old drive chain until they are changing the
Remove the old drive chain from the new drive chain.
. Apply grease to the new link pins [A] and new a-rings [B]
Engage the drive chain on the engine and rear sprockets.
Insert the link pins in the drive chain ends.
Install the a-rings [C].
Install the link plate so that the mark  faces out.
Push the link plate
by hand or plier to fix it.
.In case of the a-ring chain, be sure to set the a-rings
Set the plate holder (A) [A] and plate holder (B) [B] on the