Download  Print this page

Hub Bearing Inspection; Bearing Lubrication - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Hub Bearing (Wheel Bearing)
WHEELSITIRES
8-15
.
Engage the speedometer gear drive [A] into the notch [8]
of the front wheel hub and install the circlip [C].
Special Tool - Inside Circlip Pliers:
57001-143
Hub Bearing Inspection
Since the ball bearings are made to extremely close tol-
erances, the wear must be judged by feel rather than mea-
surement.
NOTE
o Do not remove any bearings for inspection. If any bear-
ing are removed, they will need to be replaced with new
ones.
.
Turn each bearing in the hub back and forth [A] while
checking for plays, roughness, or binding.
* If the bearing is noisy, does not spin smoothly, or has any
rough spots, replace it.
.Inspect the bearing seal [8] for tears or leakage.
*If the seal is torn or is leaking, replace the bearing.
Bearing
Lubrication
NOTE
o
Since the bearings are packed with grease and sealed
on both sides, lubricationis not required.
GJ06002BS
1 C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: