Download  Print this page

Hub Bearing (wheel Bearing); Hub Bearing Removal; Bearing Installation - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

8-14 WHEELSITIRES
Hub Bearing (Wheel Bearing)
Hub Bearing Removal
.
Remove the wheel and take out the following parts:
Collar
Coupling (out of rear hub)
Grease Seals
Circlips
Special Tool
-
Inside Circlip Pliers: 57001-143 [A]
Speedometer
Gear Drive (front hub) [B]
.
Use the bearing remover to remove the hub bearings [A].
I
CAUTION
I
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place wooden blocks under the wheel so that the
disc does not touch the ground.
OSelect a remover head that matches the bearing bore and
insert it.
OPass the remover shaft from the opposite end and engage
its tip into the groove of the head.
OTap the shaft with a hammer and remove the bearing.
Special Tools
-
Bearing Remover Shaft: 57001-1377 [B]
Bearing Remover Head, cP15 x cP17: 57001
-1267 [C]
Bearing Remover Head, cP20 x cP22: 57001
-1293 [C]
Bearing Installation
.
Before installing the wheel bearings, blow any dirt or for-
eign particles out of the hub with compressed air to pre-
vent contamination of the bearings.
.
Replace
the bearings
with new ones.
NOTE
o Install the bearings so that the marked side faces out.
.
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
.
Press in each bearing [A] right until they are it bottomed.
Special Tool- Bearing Driver Set: 57001-1129
[B]
.
Replace the circlips with a new one.
Special Tool
-
Inside Circlip Pliers: 57001-143
.
Replace the grease seal [A] with a new one and press it
in so that seal surface is flush [B] with the end of the hub
hole.
OApply high-temperature grease to the grease seal lips.
Special Tool- Bearing Driver Set: 57001-1129 [C]
GJ060606S
1 C
GJ050004S
1 C
GJ050005S
1 C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: