Download  Print this page

Rear Wheel Installation - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

8-6 WHEELSrrlRES
Wheels
Rear Wheel Installation
8 Fitthe caliper bracket [A]over the swingarm stop [B].
OApplygrease to the lipof the grease seal.
8
Place the drive chain on the sprocket and install the
wheel.
Olnsert both collars.
Olnsert the axle from the right side.
OAdjust the drive chain slack (see Final Drive chapter).
Torque - Rear Axle Nut: 108 N.m(11 kgf.m,80 ft.lb)
8 Insert a new cotter pin [A].
NOTE
o When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle, tighten the
nut clockwise fB] up to next alignment.
Olt should be within30 degree.
o Loosen once and tighten again when the slot goes past
the nearest hole.
8
Bend the cotter pin [A]over the nut.
8 Check the effectiveness of the rear brake.
A
WARNING
Do not attempt to drive the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake will
not function on the first application of the pedal if
this is not done.
GJ04071851
C
c:>
G512012851
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: