Download  Print this page

Rear Wheel Removal - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Wheels
WHEELSITIRES
8-5
8 Place the stop [A] of the speedometer gear housing be-
tween the stops [8] of the fork.
8 Install the collar on the right side of the hub.
8 Install the axle from the right side.
Torque
-
Front Axle: 98 N.m (10 kgf.m, 72 ft.lb)
Front Axle Clamp Bolts: 20 N.m (2.0 kgf.m, 14 ft.lb)
Front Caliper Mounting Bolts: 34 N.m (3.5 kgf.m,
25 ft.lb)
NOTE
o Tighten the two clamp bolts alternately two
times
toen-
sure even tightening torque.
o Tighten the top plug before tightening the upper fork
clamp
bolt.
8 Check the effectiveness of the brake.
A
WARNING
Do not attempt to drive the motorcycle until a full
brake lever is obtained by pumping the brake lever
until the pads are against the disc. The brake will
not function on the first application of the lever if
this is not done.
Rear Wheel Removal
8 Set the motorcycle on its center stand and raise the rear
wheel off the ground.
8 Loosen the drive chain (see Final Drive chapter).
8 Remove the cotter pin [A] and the rear axle nut [8].
8 Take out the chain [A] to the left side of the rear sprocket.
8 Remove the rear axle.
8 Pull the rear wheel [8] to the back to take it out of the rear
caliper.
CAUTION
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so that the disc does
not touch the ground.

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: