Download  Print this page

Drive Shaft Gear Adjustment - Kawasaki ZR-7S Service Manual

Hide thumbs


G 1130424W3
1. Ball Bearing
2. Circlip
3. Bearing Outer Race
4. Needle Bearing
5. 2nd Gear
6. Thrust Washer (Spacer)
7. 5th (Top) Gear
8. Bushing
9. Toothed Washer
10. Circlip
11. 3rd Gear
12. 4th Gear
13. Toothed Washer
Drive shaft Gear Adjustment
install the standard 1 mm (0.04 in.) thick washer
[B] on the left of the 2nd gear [A].
the drive shaft in the upper crankcase half.
OMake sure that the ball bearing and the needle bearing
are properly engaged in the set ring and the set pin.
Turn the drive shaft by hand [C] to check that it turns
* If it still does not turn smoothly, replace the washer with
one that is 0.5 mm (0.02 in.) thick.
14. Bushing
15. 1st Gear
16. Busing
17. Toothed Washer
18. 2nd Gear
19. Circlip
20. 5th (Top) Gear
21. 3rd Gear
22. Steel Ball
23. 4th Gear
24. 1st Gear
25. Bearing Outer Race


Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: