Download  Print this page

Advertisement

7-28 CRANKSHAFTITRANSMISSION
Transmission
.
Make sure to replace the removed circlip [A] with a new
one.
OAlign the gap [B] of the circlip with the groove [C] of the
spline.
Special Tool
-
Outside Circlip Pliers: 57001-144
.
To install the gear bushings on the shafts align the bush-
ing's oil hole [A] with the shaft's oil hole [B].
.
The drive shaft gears are from the 1st to the 5th gears,
from the smallest to the largest diameter. Install them in
the following sequence, while ensuring their correct ori-
entation:
Be sure that all parts and put back in the correct sequence
and all circlips and washers are properly in place.
.
The output shaft gears are from the 1st to the 5th gears,
from the largest to the smallest diameter.
Be sure that all parts are put back in the correct sequence
and all circlips and washers are properly in place.
.
Fit the steel balls into the 4th gear holes of the output shaft
as shown.
Gear (4th) [A]
Shaft [B]
Steel Balls [C]
CAUTION
When installing the 4th gear and steel balls on the
output shaft, do not apply grease to the balls to hold
them in place. This will cause the positive neutral
finder mechanism to malfunction.
OAfter assembling the 4th gear, move the gear in the direc-
tion of the shaft to check the ball-locking effect (so that
the gear does not come out of the shaft).
.
After assembly, make sure that the gears spin and slide
properly.
B
GI13042351
C
G113040851
C
G113060851
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: