Download  Print this page

Secondary Shaft And Starter Clutch; Secondary Shaft Removal - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

CRANKSHAFTfTRANSMISSION 7-19
Secondary Shaft and Starter Clutch
Secondary Shaft Removal
. Remove:
Engine
Oil (drain, see Engine Lubrication System chap-
ter)
Exhaust Pipe (see Engine Top End chapter)
Engine Sprocket Cover (see Final Drive chapter)
Clutch (see Clutch chapter)
Oil Pump (see Engine Lubrication System chapter)
Alternator Cover (see Electrical System chapter)
.
Remove the secondary shaft bearing cap [A].
.
Remove the secondary shaft nut [A].
NOTE
o Hold the alternator rotor to prevent
the secondary
shaft
from turning.
Special Tool
-
Flywheel
Holder:
57001-1313
[B)
.
Remove the secondary shaft bearing holder screws [A].
The two out of the three screws are used in common with
the oil pump mounting screws.
. Remove the tensioner holder [A].
.
Replace the tensioner holder with a new one.
.
Tap on the secondary
shaft [A] from the left of the
crankcase to remove the left bearing of the shaft from
the case. The left bearing of the shaft has the collar [8].

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: