6-4 ENGINE REMOVAUINSTALLATION
Using a jack [A], support the bottom of the engine.
Remove the engine mounting bolts  and bracket bolts
Raise the jack and take out the engine  from the right
Apply soap and water solution around the rubber damper
and install it in the bracket.
Do not apply engine oil or petroleum
the rubber damper.
Support the bottom of the engine with a jack and install
Engine Mounting Bolts, Nuts: 44 N.m (4.5 kgf.m,
Engine Bracket Bolts: 25 N.m (2.5 kgf.m, 18 ft.lb)
Run the wires, cables, and hoses properly (see General
.Install the removed parts (see the appropriate chapters).
Throttle Cable (see Fuel System chapter)
Clutch Cable (see Clutch chapter)
Choke Cable (see Fuel System chapter)
Drive Chain (see Final Drive chapter)
. Fill the engine with engine oil (see Engine Lubrication