Download  Print this page

Engine Removal/installation; Engine Removal - Kawasaki ZR-7S Service Manual

Hide thumbs

Advertisement

Engine Removal/Installation
ENGINE REMOVAUINSTALLATION 6-3
Engine Removal
.
Set the motorcycle on its center stand, squeeze the front
brake lever, and hold it with a band [A] to prevent the
motorcycle from lunging forward.
A
WARNING
Be sure to hold the front brake when removing the
engine, or the motorcycle may fall over. It could
cause an accident and injury.
CAUTION
Be sure to hold the front brake when removing the
engine, or the motorcycle may fall over. The engine
or the motorcycle could be damaged.
.
Remove (see the respective chapters):
Engine Oil (drain)
Fairing (see Frame chapter)
Seat (see Frame chapter)
Side Cover (see Frame chapter)
Fuel Tank (see Fuel System chapter)
Right Side Step Bracket Bolts [A]
Frame Ground Terminal [B]
Crankshaft Sensor, Oil Pressure Switch Wire Connector
[C]
Clutch Cable Lower End [D]
Shift Lever (see Crankshaft/Transmission
chapter)
Engine Sprocket Cover (see Final Drive chapter)
Engine Sprocket [E]
Side Stand Switch Lead Connector [F]
Side Stand Switch [G]
Neutral Switch Lead Connector [H]
Alternator Lead Connector [I]
Starter Motor Lead Terminal [J]
Air Cleaner Housing, Rear (see Fuel System chapter)
Carburetor (see Fuel System chapter)
Air Cleaner Housing, Front (see Fuel System chapter)
Horn
Ignition Coil (see Electrical System chapter)
Vacuum Switch Valve and Hoses (see Fuel System
chapter)
Exhaust Pipe and Muffler (see Engine Top End chapter)
Oil Cooler and Oil Pipe (see Engine Lubrication System
chapter)
GH040110S1
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: