Download  Print this page

Advertisement

4-10 CLUTCH
CIutch
Clutch Installation
.
Install the following parts on the drive shaft.
Spacer [A]
Sleeve [B]
Needle Bearing [C]
Clutch Housing [0]
Spacer [E]
Clutch Hub [F]
Washer [G]
Nut [I]
Olnstall the spacer [A] with its chamfered side facing the
crankcase.
OReplace the clutch hub nut with a new one.
OHolding the clutch hub, tighten the clutch hub nut.
Special Tool-
Clutch Holder: 57001-1243
Torque
-
Clutch Hub Nut: 132 N.m (13.5 kgf.m,
98
ft.lb)
.Install
the plates alternately in the following order: first
the cork-base friction plate [A], then the steel plate, and
paper-base friction plates [B] and steel plates at five time.
.Install
the last cork-base friction plate [C] by aligning its
protrusions with the shallow grooves.
CAUTION
If new plates are installed, apply engine oil to the
surfaces of each plate to avoid clutch plate seizure.
GF060409S2
C
GF06013BS2
C

Advertisement

Table of Contents

   Also See for Kawasaki ZR-7S

Comments to this Manuals

Symbols: 0
Latest comments: