Meter, Gauge
•
Check the following items.
○
The needles of the fuel gauge [A], speedometer [B],
tachometer [C] and water temperature gauge [D] mo-
mentarily point their last readings and back to the
minimum position.
○
The needle [E] of the water temperature gauge moves
from C to H position and the needle stays there.
If the meter unit does not work, replace the meter base
(see Meter Unit Disassembly).
○
The flashings of the gear position segments, FUEL and
(– – –) in the display do not failure of the meter unit.
○
Currently, for the meter is disconnected from the main
harness each flashing occur.
○
The flashing of the gear position segments is commu-
nication error to the ECU.
○
The flashings of the FUEL and (– – –) are open of the
fuel level gauge.
○
Normally, each flashing disappears when the meter unit
is connected to main harness.
Check 3: Left Turn Signal Indicator Light (LED) Inspec-
tion
•
Connect the leads in the same circuit as Check 2.
•
Connect the terminal [1] to the battery (+) terminal.
•
Check that the left turn signal indicator light (LED) [A]
goes on.
If the indicator light does not go on, replace the meter
base (see Meter Unit Disassembly).
Check 4: Right Turn Signal Indicator Light (LED) In-
spection
•
Connect the leads in the same circuit as Check 2.
•
Connect the terminal [2] to the battery (+) terminal.
NOTE
ELECTRICAL SYSTEM 16-83
Comments to this Manuals
Latest comments: