16-80 ELECTRICAL SYSTEM
Turn the ignition switch to ON.
Check that the needle stops near the position correspond-
ing to resistance.
Water Temperature Gauge Indication
If the needle does not stop to the specified position, re-
place the meter base (see Meter Unit Disassembly).
Start the engine in the neutral position.
Check that the needle [A] in the tachometer moves ac-
cording to the throttle opening and closing.
If the needle does not move to the proper position, replace
the meter base (see Meter Unit Disassembly).
Idle Speed Indication Inspection
Refer to the Idle Speed Adjustment in the Periodic Main-
If the idle speed cannot adjust, check the following items.
Water Temperature Sensor (see Water Temperature
Right Handlebar Switch Housing (see Switch Inspection)
If the above items are good, replace the meter base
Gear Position Indication Inspection
Turn the ignition switch to ON in the neutral position.
The N mark [A] appears and the neutral indicator light [B]
(LED) goes on in the display.
Set the low gear position, check that the display changes
to 1 mark.
Using the center stand, raise the rear wheel off the
Start the engine, and change the gear position.
Check that the display corresponding to each gear posi-
tion (1, 2, 3, 4, 5 or OD) appears.
If the display function does not work, check the gear po-
sition switch (see Gear Position Switch Inspection)
If the switch is good, replace the meter base and/or ECU.
1/2 (middle) [B]