Automatic Turn Signal Canceling System
Distance Sensor System Inspection
Battery Case Cover (see Battery Removal)
Turn Signal Control Relay
Do not disconnect the connector.
Use the jack to lift the rear wheel (see Rear Wheel Re-
moval in the Wheel/Tires chapter).
Special Tool - Jack: 57001-1238
Set the hand tester [A] to the DC 25 V range and connect
it to the LB lead terminal [B] and battery (–) terminal [C]
Hand Tester (+) → LB Lead Terminal
Hand Tester (–) → Battery (–) Terminal
Turn the rear wheel slowly to see that the tester's pointer
fluctuates repeated by reading 0.5 V and 12 V.
If the tester's pointer fluctuates, distance sensor is nor-
If the tester's pointer does not fluctuate, inspect the fol-
Speed Sensor (see Speed Sensor Output Voltage In-
spection in the Fuel System (DFI) chapter)
Speed Signal Inspection (see Meter Unit Inspection)
Harness (see Wiring Inspection)
If the above parts are good, replace the turn signal control
Turn Signal Light Bulb Replacement
Turn Signal Light Lens Screw [A]
Turn the lens [A] counterclockwise [B] and remove the
turn signal light assembly.
ELECTRICAL SYSTEM 16-65