Remove the inner [A] and outer [B] guide bushings,
washer [C] and oil seal [D] from the inner tube.
Front Fork Assembly
Replace the following parts with new ones.
Dust Seal [A]
Retaining Ring [B]
Oil Seal [C]
Inner Guide Bushing [D]
Outer Guide Bushing [E]
Bottom Allen Bolt Gasket [F]
Put the cylinder unit [A] with the spring into the inner tube
[B], protruding from the inner tube, and install the cylinder
base [C] onto the bottom end of the cylinder unit.
Install the cylinder base with the tapered end [D] up.
Install the inner tube, cylinder unit, and cylinder base as
a set into the outer tube.
Install the new guide bushing [A] with a used guide bush-
ing [B] on it by tapping the used guide bushing with fork
oil seal driver [C] until it stops.
Special Tool - Front Fork Oil Seal Driver: 57001-1219
Apply grease to the oil seal lips.
Install the washer [A] and the oil seal [B] into the outer
Turn the flat side [C] of the seal upward.
Special Tool - Front Fork Oil Seal Driver [D]: 57001-1219
Install the retaining ring.