2-20 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
The idle speed goes up 50 r/min (rpm) at one time by
pushing the "MODE-A" switch.
When pushing the "MODE-A" switch, the value on the
display shows the "+50" [A] (this shows 1 000 r/min (rpm)).
The idle speed goes down 50 r/min (rpm) at one time by
turning the "MODE-B" switch.
When pushing the "MODE-B" switch, the value on the
display shows the "–50" [B] (this shows 900 r/min (rpm)).
When pushing the "MODE-B" switch for more than two
seconds, the value on the display shows the "0" [C] (ini-
tial setting value).
The idle speed can be set with 850
Open and close the throttle a few times to make sure that
the idle speed is within the specified range. Readjust if
Any of the following procedures ends idle speed adjusting
Push the "S" button for more than two seconds.
When the engine is stopped.
Fuel Hose Inspection (fuel leak, damage,
If the motorcycle is not properly handled, the high pres-
sure inside the fuel line can cause fuel to leak [A] or the
hose to burst. Remove the fuel tank (see Fuel Tank Re-
moval in the Fuel System (DFI) chapter) and check the
Replace the fuel hose if any fraying, cracks [B] or bulges
[C] are noticed.
1 100 r/min (rpm).