K-ACT ABS (Equipped Models)
•
Do the 2nd step test.
○
Disconnect the K-ACT ABS hydraulic unit connector and
fluid pressure sensor connector.
○
Check for continuity between the white/red lead terminal
of the main harness side connector [A] and white/red lead
terminal of the main harness side connector [B].
○
Check for continuity between the black/red lead terminal
of the main harness side connector [C] and black/red lead
terminal of the main harness side connector [D].
If there is the continuity in the lead, proceed the 3rd step.
If there is not the continuity in the lead, replace or repair
the main harness.
•
Do the 3rd step test.
○
Disconnect the fluid pressure sensor connector.
○
Connect the hand tester [A] to the fluid pressure sensor
connector [B].
Special Tool - Hand Tester: 57001-1394
○
Measure the fluid pressure sensor resistance.
Fluid Pressure Sensor Resistance
For Input Fluid Pressure Sensor (Rear Brake)
Connections:
Standard:
If the reading is out of the standard, replace the K-ACT
ABS hydraulic unit.
If the reading is within the standard, replace the K-ACT
ABS hydraulic unit.
W/R lead [C] ←→ BK/R lead [D]
100 ~ 150 kΩ
BRAKES 12-67
Comments to this Manuals
Latest comments: