K-ACT ABS (Equipped Models)
Do the 5th step test.
Check for continuity between the positive cable [A] of the
battery and red/white lead terminal of the main harness
side connector [B].
If there is the continuity in the lead, proceed the 4th step.
If there is not the continuity in the lead, replace or repair
the main harness.
Do the 6th step test.
Recheck the service code indication; erase the service
code, perform the pre-diagnosis inspection 1 and 2, and
retrieve the service code.
If the K-ACT ABS indicator light (LED) [A] lit, faulty K-ACT
ABS pump motor relay in the K-ACT ABS hydraulic unit.
Replace the K-ACT ABS hydraulic unit.
If the K-ACT ABS indicator light (LED) unlit, K-ACT ABS
is normal (service code is not stored; temporary failure.).
Front Wheel Rotation Sensor Signal Abnormal
(Service Code 42)
Do the 1st step test.
Measure the air gap between the front wheel rotation sen-
sor and sensor rotor.
Thickness Gauge [A]
Standard: 1.0 mm (0.039 in.)
If the measurement is over standard, check each part
for deformation and looseness and correct accordingly.
Recheck the air gap.
If the measurement is correct, proceed the 2nd step.
Do the 2nd step test.
Check that there is iron or other magnetic deposits be-
tween the sensor [A] and sensor rotor [B], and the sensor
rotor slots for obstructions.
Check the installation condition of the sensor for loose-
Check the sensor and sensor rotor tip for deformation or
damage (e.g., chipped sensor rotor teeth).
If the sensor and sensor rotor in bad condition, remove the
any deposits. Install the properly or replace faulty part.
If the all correct, proceed the 3rd step.