K-ACT ABS (Equipped Models)
Remove the right side cover (see Right Side Cover Re-
moval in the Frame chapter).
Ground the self-diagnosis terminal (gray) [A] to the battery
(–) terminal, using a auxiliary lead.
Turn on the ignition switch.
Count the blinks of the light to read the service code.
Keep the auxiliary lead ground until you finish reading the
Service Code Clearing Procedures
Start the service code erase mode with the following pro-
The erase mode starts when the K-ACT ABS self
-diagnosis terminal is disconnected from the ground
terminal after starting the self-diagnosis mode.
The service code can be erased by grounding and un-
grounding (each time for at least one second) the K-ACT
ABS self-diagnosis terminal three times or more within
about 12.5 seconds after starting the erase mode.
The K-ACT ABS indicator light (LED) remains lit during
the erase mode and after erasing.
Once erasing is finished, enter the self-diagnosis mode
again to confirm that the service codes have been erased.
If the K-ACT ABS has been reset and all codes have been
erased, only start code 12 will be shown.