Brake Lever, Brake Pedal
Brake Lever Position Adjustment
Push the lever forward and turn the adjuster [A].
Brake Pedal Position Inspection
Check that the brake pedal [A] is in the correct position.
About 100 mm (3.94 in.) [B] (height from
pedal top to footboard top [C])
If it is incorrect, adjust the brake pedal position.
Brake Pedal Position Adjustment
Usually it is not necessary to adjust the pedal position,
but always adjust it when push rod locknut has been
If the push rod length cannot be adjusted by turning the
clevis, the brake pedal may be deformed or incorrectly
Loosen the locknut [A] and turn the push rod with the hex
head [B] to achieve the correct pedal position.
If the length [C] shown is 70 ±1 mm (2.76 ±0.04 in.), the
pedal position will be within the standard range.
Torque - Rear Master Cylinder Push Rod Locknut: 17.2 N·m
(1.8 kgf·m, 13 ft·lb)
Check the brake light switch operation (see Brake Light
Switch Operation Inspection in the Periodic Maintenance
Brake Pedal Removal
Front Footboard Bracket Bolts [A]
Front Guard Bolt [B]
Slide the front guard forward.