Pulley and Coupling
Engine Pulley Installation
Fit the grooves inside the pulley onto the splines on the
Replace the washer with a new one.
Apply molybdenum disulfide grease to the threads of
the output shaft and seating surface of the engine pulley
If the grease stuck to the pulley or drive belt, wipe up it.
Hold the engine pulley steady with the pulley holder, and
tighten the pulley mounting nut.
Torque - Engine Pulley Mounting Nut: 175 N·m (18.0 kgf·m,
Special Tools - Pulley Holder: 57001-1572
Bend the one side of the washer [A] over the nut.
Adjust the drive belt deflection (see Drive Belt Deflection
Adjustment in the Periodic Maintenance chapter).
Install the removed parts (see appropriate chapters).
Rear Pulley Removal
Rear Wheel (see Rear Wheel Removal in the
Rear Pulley Mounting Nuts [A] and Washers
Rear Pulley [B]
Rear Pulley Installation
Install the rear pulley plate [A].
Turn the bent edge to outside.
Apply a non-permanent locking agent to the rear pulley
plate bolts [B].
Torque - Rear Pulley Plate Bolts: 6.9 N·m (0.70 kgf·m, 61
Replace the rear pulley mounting nuts with new ones.
Install the rear pulley, washers and rear pulley mounting
Torque - Rear Pulley Mounting Nuts: 59 N·m (6.0 kgf·m, 44
FINAL DRIVE 11-11