10-18 WHEELS/TIRES
Hub Bearing
○
Replace the circlips with new ones.
Special Tool - Inside Circlip Pliers: 57001-143
•
Replace the grease seals with new ones.
•
Press in the grease seals [A] so that the seal surface is
flush [B] with the end of the hole.
○
Apply high-temperature grease to the grease seal lips.
Special Tool - Bearing Driver Set [C]: 57001-1129
Hub Bearings Inspection
○
Since the hub bearings are made to extremely close tol-
erance, the clearance cannot normally be measured.
○
Do not remove any bearings for inspection. If any bear-
ings are removed, they will need to be replaced with
new ones.
•
Turn each bearing in the hub back and forth [A] while
checking for plays, roughness, or binding.
If bearing play, roughness, or binding is found, replace
the bearing.
•
Examine the bearing seal [B] for tears or leakage.
If the seal is torn or is leaking, replace the bearing.
Hub Bearings Lubrication
○
Since the hub bearings are packed with grease and
sealed, lubrication is not required.
NOTE
NOTE
Comments to this Manuals
Latest comments: