Clutch Cover Removal
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
Remove the exhaust pipe (see Exhaust Pipe Removal in
the Engine Top End chapter)
Unscrew the clutch cover bolts (19) [A]
Clutch Cover Installation
When the new needle bearing [A] is installed in the clutch
cover, press and insert the needle bearing so that the
bearing surface is flush with the end of the hole.
Special Tools - Bearing Driver Set: 57001-1129
Install the needle bearings so that the manufacture's
make face out.
Be sure that the dowel pins [A] are in position.
Replace the clutch cover gasket with a new one.
Torque - Clutch Cover Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)
L = 50 mm (2.0 in.) [A]
L = 65 mm (2.6 in.) [B]
L = 75 mm (3.0 in.) [C]
Install the removed parts (see appropriate chapter).
Clutch Outer Covers Removal
Detach the clutch outer mark cover [A]
Front Outer Clutch Cover Bolts [B]
Front Outer Clutch Cover [C]
Rear Outer Clutch Cover Bolts [D]
Rear Outer Clutch Cover [E]