Clutch Master Cylinder
Clutch Lever Adjustment
The adjuster has 8 positions so that the clutch lever posi-
tion can be adjusted to suit the operator's hand.
Push the lever forward and turn the adjuster [A].
Clutch Master Cylinder Removal
Starter Lockout Switch Connectors [A]
Cruise Control Cancel Switch (Clutch) Connectors [B]
Remove the banjo bolt [C] to disconnect the clutch hose
from the master cylinder (see Clutch Hose and Pipe Re-
placement in the Periodic Maintenance chapter).
Unscrew the clamp bolts [A], and take off the master cylin-
der [B] as an assembly with the clutch lever, starter lock-
out switch, and cruise control cancel switch installed.
Immediately wash away any clutch fluid that spills.
Clutch Master Cylinder Installation
Install the clutch master cylinder [A] so that the mating
surface [B] of the master cylinder is aligned with the punch
mark [C] of the handlebar.
Tighten the upper clamp bolt first, then the lower clamp
Torque - Clutch Master Cylinder Clamp Bolts: 11 N·m (1.1
kgf·m, 97 in·lb)
Replace the washers on each side of the hose fitting with
Torque - Clutch Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18
Replenish the clutch fluid into the reservoir and bleed the
clutch line (see Clutch Line Bleeding).
Check that the clutch line has proper fluid pressure and
no fluid leakage.
Clutch Master Cylinder Disassembly/Assembly
Refer to the Clutch Master Cylinder Rubber Parts Re-
placement in the Periodic Maintenance chapter.