Throttle Body Assy
Vacuum Hose [A]
Cruise Control Cancel Switch (Throttle) Lead Connector
Throttle Position Sensor Connector [A]
Accelerator Position Sensor Connector [B]
Throttle Body Assy Bolts [C]
Throttle Body Assy [D] (from Inlet Manifold)
Throttle Cable Stopper Plate Screw [A]
Throttle Cables [C]
Throttle Body Assy [D]
Stuff a piece of lint-free clean cloth into the inlet ports of
the inlet manifold to keep dirt out of the engine.
If dirt gets into the engine, excessive engine wear
and possibly engine damage will occur.
Throttle Body Assy Installation
Check the throttle bores [A] for carbon deposits.
If any carbon accumulates, wipe the carbon off the throttle
bores, using a lint-free cloth [B] penetrated with a high
-flash point solvent.
Apply a thin coat of grease to the throttle cable lower ends.
Fit the accelerator cable end [A] and the decelerator cable
end [B] into the throttle pulley.
Hold the cables with the stopper plate [C].
Torque - Throttle Cable Stopper Plate Screw [D]: 2.0 N·m
(0.20 kgf·m, 18 in·lb)
Install the clamp securely and tighten the screw [D].
Run the throttle cables correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
FUEL SYSTEM (DFI) 3-107