Functional Description - Makita 1002BA Instruction Manual

13. Do not leave the tool running. Operate the tool
only when hand-held.
14. When leaving the planer, switch off and set it
with the front base up on a wooden block, so
that the blades do not contact anything.
15. Always change both blades or covers on the
drum, otherwise the resulting imbalance will
cause vibration and shorten tool life.
16. Wait for complete run-down before putting the
tool aside.
17. Use only Makita blades specified in this
manual.
18. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting front base
1
002599
The front base is factory-adjusted to allow concave cuts
with a radios of 320 mm (12 - 5/8"). For concave cuts with
the tool's minimum radios of 300 mm (11 - 3/4") loosen
the wing bolt on either side and raise the front base as far
as it will go. Then retighten the two wing bolts firmly to
USD201-2
secure the front base.
Adjusting depth of cut
002546
Depth of cut may be adjusted by simply turning the knob
on the front of the tool.
Switch action
1
002550
4
3
2
1
2
1. Wing bolt
2. Front base
3. Wing bolt
1. Knob
1. Switch trigger
2. Lock button