Adjustment - Shoprider TE-889NRS Owner's Manual

Tiller Angle Adjustment (Fig. 1)
The red lever located on the left hand side at
the joint base of the tiller is used for tiller angle
adjustment. Push the lever to release the
pin and select the required tiller angle. Refit
Tiller Angle
the pin into one of the five location holes to
Adjustable Lever
complete the adjustment.
Fig. 1
Armrest Angle Adjustment (Fig. 2)
Flip up the armrests to allow access to the
adjustable bolt and lock nut, unscrew the
lock-nut and screw the bolt in or out to
Adjustable
increase or decrease the angle. Re-tighten
Bolt
the lock-nut. Your scooter is dispatched from the
Lock-Nut
factory with the armrests set parallel to the floor.
Fig. 2
Armrest Height Adjustment (Fig. 3)
The vertical square tube connected with
the armrest can be reset to the desired
position by re-tightening the hand knob
for armrest height adjustment.
Armrest Adjustable
Hand Knob
Fig. 3
8