Schematic Diagram - Sony WALKMAN WM-EX910 Service Manual

Q Q
6-3. SCHEMATIC DIAGRAM • See page 20 for IC Block Diagrams.
3 7 6 3 1 5 1 5 0
T E
L 1 3 9 4 2 2 9 6 5 1 3
w w w
.
– 17 –
x a o u 1 6 3
y
i
http://www.xiaoyu163.com
8
Q Q
3 7 6 3 1
c o
.
– 18 –
http://www.xiaoyu163.com
• Waveforms
2 4
9 9 8
1 IC701 5 (LX)
1 V/DIV, 10 µs/DIV
3 µ s
2 IC705 wh (CB2)
500 mV/DIV, 20 µs/DIV
61 µ s
3 IC705 wl (XT1)
1 V/DIV, 20 µs/DIV
5 1 5 0 8 9 2 4 9
30 µ s
m
– 19 –
WM-EX910
2
9 9
4 IC705 ef (OSC1)
1 V/DIV, 1 µs/DIV
3 Vp-p 2.4 Vp-p
1.8 µ s
5 IC705 rg (MOTOR W), rh (MOTOR V),
rj (MOTOR U)
500 mV/DIV, 2 ms/DIV
1.2 Vp-p 1.3 Vp-p
6.6 ms
8 2 9 9
2.2 Vp-p
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/ W or less unless otherwise
4
specified.
• % : indicates tolerance.
• C : panel designation.
• A : B+ Line.
• U : B+ Line.
• H : adjustment for repair.
• Power voltage is dc 1.3 V and fed with regulated dc power
supply from battery terminal.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : PLAY
( ) : STOP
[ ] : DOLBY NR ON
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
E : PLAY