Assembly; Base And Column Assembly - Jet JWDP-12 Operating Instructions And Parts Manual

6.0 Assembly

6.1 Base and column assembly

Refer to Figure 3:
1. Place base (D) on a level floor.
2. Place column assembly (E) on base (D) and align
holes in column support with holes in base.
3. Using a 5/8-in wrench, secure column (E) with
four M10 x 25 hex cap screws (N) to the base.
6.2 Table and rack
Refer to Figure 4:
Note: If table arm/support assembly (C) and rack (E
are already installed on column (E), proceed to step 4.
Otherwise, begin with step 1.
1. Remove rack ring (E
(E). Note which end of the rack is up. It must be
reinstalled later with the same side up.
2. Place rack (E ) inside table support (C) such that
3
the teeth of the rack (E
gear on the end of the table crank handle shaft
(C ).
1
3. Slide table arm/support assembly (C) together
with the rack (E ) onto the column (E) as shown.
3
4. Place rack ring (E
1
down so it rests against rack (E
tighten setscrew (E
(provided).
5. Place table (B) onto table arm (C), positioning it
as shown in Figure 4. Secure table with lock
handle (K).
6. Secure table extension (B
extension lock knobs (Q).
6.3 Table height adjust and lock
handles
Refer to Figure 4:
1. Loosen the setscrew (R
adjust handle (R).
2. Slide the handle (R) onto the table bracket shaft (C
3. Turn the handle (R) until the setscrew (R
the flat section of the shaft (C
setscrew (R ) with a 3mm hex wrench to secure
1
the handle.
4. Thread the column lock handle (K) into the back
side of the table bracket (C) opposite the height
adjust handle (R).
) and rack (E ) from column
1 3
) mesh with the pinion
3
) onto column (E), sliding it
) as shown, and
3
) with a 3mm hex wrench
2
) with two table
1
) on the table height
1
) is on
1
) and tighten the
1
)
3
).
1
7
Figure 3
Figure 4