Zanussi ZCM6601 User Manual page 30

Gas burners
NORMAL
POWER
BURNER
kW
Auxiliary 1,0
burner
Semi-rapid 2,0
burner
Rapid burn- 3,0 (nat. gas)
er 2,8 (LPG)
Gas Connection
Choose fixed connections or use a flexible pipe in stain-
less steel in compliance with the regulation in force. If
you use flexible metallic pipes, be careful they do not
come in touch with mobile parts or they are not squeezed.
Flexible nonmetal pipes connection
If it is possible to easily control the connection in its
full area, you can use a flexible pipe. The flexible pipe
must be tightly attached by clamps.
Installation: use the rubber pipe holder. Always engage
the gasket. Then continue with the gas connection. The
flexible pipe is prepared for apply when:
– it can not get hot more than room temperature, high-
er than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting edges or corners;
– it can be easily examined in order to check its condi-
tion.
The control of preservation of the flexible pipe consists
in checking that:
– it does not show cracks, cuts, marks of burnings on
the two ends and on its full length;
– the material is not hardened, but shows its correct
elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
30
REDUCED
NATURAL GAS
POWER
G20 (2H) - 20 mbar
inj. 1/100
kW
mm
0,33 70
0,45 96
0,75 119
NORMAL POWER
(Butane/Propane) G30/31-30 mbar
inj. 1/100
m³/h
mm
0,095 50
0,190 71
0,286 86
If one or more defects are visible, do not repair the pipe,
but replace it.
Important! When installation is complete, make sure
that the seal of each pipe fitting is correct. Use a soapy
solution, not a flame!
Warning! Do not set the appliance on a base
Levelling
Use small feet on the bottom of appliance to set same
level of cooker top surface with other surfaces
Electrical installation
Warning! Only a qualified and competent person
must do the electrical installation.
The manufacturer is not responsible if you do not
follow safety precautions from chapter "Safety In-
formation".
This appliance is only supplied with a main cable.
MANUFACTURER:
C.so Lino Zanussi, 26-33080 Porcia (PN), Italy.
LPG
g/h
G30 G31
72 71
145 143
204 200