Motorola EMS APX 6000 User Manual page 34


Making a Dynamic Priority Change (Conventional
Scan Only)
While the radio is scanning, the dynamic priority change feature
allows you to temporarily change any channel in a scan list
(except for the Priority-One channel) to the Priority-Two
channel.
This change remains in effect until scan is turned off. Scan then
reverts to the preprogrammed (original) setting.
Procedure:
1
When the radio locks onto the channel designated as the
new Priority-Two channel, press the preprogrammed
Dynamic Priority button.
2
The radio continues scanning the remaining channels in the
list.

Deleting a Nuisance Channel
If a channel continually generates unwanted calls or noise
(termed a "nuisance" channel), you can temporarily remove the
unwanted channel from the scan list.
This capability does not apply to priority channels or the
designated transmit channel.
Procedure:
1
When the radio is locked onto the channel to be deleted,
press the preprogrammed Nuisance Delete button.
OR
< >
or to Nuis. Press the Menu Select button directly below
Nuis.
2
The radio continues scanning the remaining channels in the
list.

Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, do one of the
following:
•
Turn the radio off and then turning it on again.
OR
•
Stop and restart a scan via the preprogrammed Scan button
or menu.
OR
•
Change the channel via the 16-Position Select knob.
11/2/15 34
English