Removing And Replacing The Batterypack; Engaging The Transporting Safety; Device (Switch-On Lock); Selecting Gear - Metabo BSZ 9.6 Operating Instructions Manual

ENGLISH
ENG
7.1 Removing and replacing the
batterypack
Removing
Press in the release button (5) and remove the
battery pack (6).
Replacing
Push the battery pack (6) fully into its housing
until it locks into position.
7.2 Setting the direction of rotation,

engaging the transporting safety

device (switch-on lock)

Only activate the changeover switch (9)
when the motor is at a standstill!
Activate the changeover switch (direction of
rotation setting, transporting safety device) (9).
See page 3 (please unfold):
R = right-hand rotation selected
L = left-hand (reverse) rotation selected
0 = central setting: transporting position
(switch-on lock engaged)
7.3

Selecting gear

Do not operate the slide-switch (4)
unless the motor is at a standstill.
Position the slide-switch (4) as required:
= 1st gear (low speed, exceptionally high
torque)
= 2nd gear (high speed)
7.4

Setting torque control, drilling,

impact drilling
Turn selector barrel (torque, drilling, impact
drilling) (2).
1... = Torque setting
(with torque control)
= Drill setting
(max. torque)
= impact drill setting

(depending on equipment)

7.5 Switching impulse mode on and off
(depending on equipment)
Do not work with impulse mode swit-
ched on over an extended period of
time (the motor is liable to overheat).
Activate rocker switch for impulse function (3).
0 = Impulse mode switched off
= Impulse mode switched on
12
7.6 Switching the power tool on and off,
setting speed
Position the trigger-switch (8) as required.
The speed can be set to any value within its
range.
Note:The noise that the machine makes when
it is switched off is due to the model (quick stop)
and has no influence on the function or the
service life of the machine.
7.7

Rapid-action keyless chuck

1
GRIP, ZU
Opening
Twist the sleeve (1) towards "AUF, RELEASE".
Note for machines with the designation SBZ...:
The grating sound which may be heard when
the drill chuck is opened is functional and is
stopped by turning the sleeve in the opposite
direction.
Clamping bit
Open the rapid-action keyless chuck and insert
the bit fully.
Twist the sleeve (1) towards "GRIP, ZU", until
the bit is clamped tightly in the chuck.
When using soft bit shanks, it may be neces-
sary to retighten the chuck after a short period
of operation.
On machines with the designation SBZ...:
Turn sleeve (1) towards "GRIP, ZU" until the
mechanical resistance which can be felt is
overcome.
Caution! The tool is not yet clamped! Keep
turning the sleeve (it must "click" when
turning) until it cannot be turned any further -
only now is the tool securely clamped.
AUF, RELEASE