Self-Diagnosis Display - Sony DCR-IP210E Operating Instructions Manual

English

Self-diagnosis display

Your camcorder has a self-diagnosis display
function.
This function displays the current condition of
your camcorder as a five-digit code (a combination
of a letter and figures) on the LCD screen. If a five-
digit code is displayed, check the following code
chart. The last two digits (indicated by ss) will
differ depending on the state of your camcorder.
Five-digit display
C:04:ss
C:21:ss
C:22:ss
C:31:ss
C:32:ss
E:20:ss
E:61:ss
E:62:ss
If you are unable to rectify the problem even if you try corrective actions a few times, contact your
Sony dealer or local authorised Sony service facility.
Downloaded From VideoCamera-Manual.com Manuals
Cause and/or Corrective Actions
• You are using a battery pack that is not an "InfoLITHIUM"
battery pack.
c Use an "InfoLITHIUM" battery pack (p. 266).
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at least
one hour to acclimatise (p. 271).
• The video heads are dirty.
c Clean the heads using the cleaning cassette (optional)
(p. 272).
• A malfunction other than the above that you can service has
occurred.
c Remove the cassette and insert it again, then operate your
camcorder. Do not perform this operation if moisture starts
to condense (p. 271).
c Disconnect the mains lead of the AC power adaptor or take
out the battery pack. After reconnecting the power source,
operate your camcorder.
• A malfunction that you cannot service has occurred.
c Contact your Sony dealer or local authorised Sony service
facility and inform them of the 5-digit code.
(example: E:61:10)
LCD screen or Viewfinder
C:21:00
Self-diagnosis display
• C:ss:ss
You can service your camcorder
yourself.
• E:ss:ss
Contact your Sony dealer or local
authorised Sony facility.
251