External Display - Panasonic CF-R1 Series Reference Manual

External Display

VGA Conversion Cable
Attach with the mark
facing upward.
To remove: Remove
while pressing on the
latch on the bottom.
External Display Port
Use the included VGA conversion cable to connect an external display.
1
Power off your computer
Do not shut down using the standby or hibernation function.
2
Attach the core
3
Connect the VGA conversion cable to the external display port
on your computer
4
Connect the external display to the VGA conversion cable
5
Turn on the external display, then turn on your computer
After Windows starts up, the screen is displayed on the display destination
set in the following menu.
Windows 2000
[Start] - [Settings] - [Control Panel] - [Intel® Extreme Graphics] - [Devices]
Windows XP
[start] - [Control Panel] - [Other Control Panel Options] - [Intel® Extreme Graph-
ics] - [Devices]
It is possible to change the setting to display only on the external display or
on both the internal LCD and the external display with Fn + F3 .
NOTE
The display destination after resuming from hibernation mode or after
restarting may differ from the display destination before entering hi-
bernation mode or before restarting.
When changing the display destination after Windows has started, do
not press any keys or slide the power switch until the display destina-
tion has changed completely.
Fn + F3 does not work when [Command Prompt] screen is set to
"Full Screen".
If the screen resolution is set to 800 × 600 or less and the screen is set
to simultaneous display, the screen will not fill up the entire display.
6
Set your external display
Windows 2000
Select [Start] - [Settings] - [Control Panel] - [Display] - [Settings] - [Advanced] -
[Monitor] and make the monitor settings.
When a monitor that does not conform to the Plug & Play standards is con-
nected, select [Monitor] - [Properties] - [Driver] - [Update Driver] to update the
driver.
Windows XP
Select [start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings]
- [Advanced] - [Monitor] and make the monitor settings.
When a monitor that does not conform to the Plug & Play standards is con-
nected, select [Monitor] - [Properties] - [Driver] - [Update Driver] to update the
driver.
NOTE
For more detailed information, refer to the operation manual of the
external display.
Set number of colors, screen resolution, or refresh rate correctly to
suit the external display.
( "Starting Up/Shutting Down")
( "First-time Operation")
38