Set Per-Cup Quantity - Siemens TK76K573 Instruction Manual

Empty the container. The appliance is
ready to use once more.
Rinsing the filter simultaneously activates
the setting for the
Service - change filter
display.
The filter is no longer effective when the
Service - change filter
or at the latest after two months. It needs to
be replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance). Replacement
filters can be obtained from retailers or cus-
tomer service (see "Accessories").
After every filter change the filter must first
be rinsed. Proceed as described at the be-
ginning of this section.
If no new filter is used, turn the water filter
setting to .
Off
You can find detailed information about the
water filter in the enclosed filter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the filter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
Further entries in the Settings menu:
> Descaling program
to descale the appliance, press
stop (8) and run the descaling programme
(see "Descaling").
> Cleaning program
to clean the appliance, press
stop (8) and run the cleaning programme
(see "Cleaning").
> Calc'n'Clean
descale and clean the appliance at the
same time, press
and run the Calc'n'Clean programme
(see "Calc'n'Clean").
> Factory settings
your own settings and reset the factory set-
tings. To activate the factory settings, press
start stop (8).
display appears,
: If you want
start
: If you want
start
: If you want to
start stop (8)
: You can cancel
The appliance can also be reset to
the factory settings as follows:
1. Switch the appliance off fully at the
power switch O/I (1).
2. Press and
<
time, hold them down, and switch the
appliance on again at the power switch
O/I (1).
The factory settings are reactivated.
Set per­cup quantity
The per-cup quantity can be adjusted
individually to suit your cups. It can be set
separately for each type of drink and each
cup size.
1. To call up the default settings, keep
(7) depressed for at least
i
3 seconds.
2. Select
Per-cup quantities
3. Press start stop (8).
4. Select the type of drink with the rotary
knob (4).
5. Press .
>
6. Select the cup size with the rotary knob
(4).
7. Press > .
8. Set the per-cup quantity with the rotary
knob (4).
< returns you to cup size and drink
selection. To quit the default settings, press
i (7). The settings are stored.
When the cup size is selected, the changed
per-cup quantity is shown graphically:
*
1x
Coffee
Per-cup quantity reduced compared
with standard setting
Per-cup quantity increased compared
with standard setting
Standard
de en
(3) at the same
>
with
>
+
1x
45