Remote Control - Technika DVDID-501 Owner's Manual

reMote controL

USING THE REMOTE CONTROL
• Point the remote control at the REMOTE SENSOR located on the unit.
• When using this unit in a very brightly lit area, the infrared REMOTE CONTROL SENSOR may
not work properly.
• The recommended effective distance for using the remote control is about 16 feet (5 metres).
TO CHANGE THE REMOTE CONTROL BATTERy
1. Open the battery door.
BATTERy REPLACEMENT
When the batteries become weak, the operating distance of the remote control will be greatly reduced
and you will need to replace the batteries.
Note:
• If the Remote Control is not going to be used for a long time, remove the batteries to avoid damage
caused by battery leakage corrosion.
• Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
WARNING:
• Do not dispose of batteries in a fire or they may leak and/or explode.
• The battery shall not be exposed to excessive heat such as sunshine, fire or the
like.
• Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
2. Insert two "AAA" batteries.
7
+
_
_
+