Installation - Honeywell MM14CCS User Manual

INSTALLATION

It is important that the installation instructions below are followed for successful installation of this
portable air conditioner. Please call Customer Support if you have any difficulties or queries regarding
these installation procedures.
Installation kit:
1. Flange Fixture......................................
2. Hose Connector..................................
3. Hole Cover..........................................
4. Plastic Hose........................................
5. Exhaust Nozzle....................................
Through an Open Window
1. Install the plastic hose with exhaust nozzle and hose connector on both sides. Ensure proper fit on
both ends.
2. Connect the plastic hose to the rear exhaust
outlet on the back of the unit. Push-in until it is
locked in place.
Through a Drilled Hole in the Wall or Window Through a Drilled Hole in the Wall or Window
If required, your Portable Air Conditioner can be installed semi-permanently. If required, your Portable Air Conditioner can be installed semi-permanently. If required, your Portable Air Conditioner can be installed semi-permanently.
1. Drill a hole in an outside wall or through a window pane. Respect the height and dimensions of the
hole given in Fig. 2 and Fig. 3.
2. Insert & secure the Flange Fixture into the newly drilled hole.
3. Fix one end of the Plastic Hose into the Flange Fixture that was secured on the wall.
4. Fix the other end of the Plastic Hose onto the Hose Connector and then onto the rear Exhaust outlet
of the unit (See Fig. 3).
NOTE: When the unit is not in use, remove the Plastic Hose from the Flange Fixture on the wall and use
the included Hole Cover to cover the hole on the wall.
Fig.1
30 cm 30 cm
11.8" 11.8"
1 Piece
2 Pieces
1 Piece
1 Piece
1 Piece
Fig.2
In In the
the wooden
30 cm 30 cm window kickboard
11.8" 11.8" panel of a french
window
EN
1 2
x 1
4
x 1
3. Extend the plastic hose through an open
window and close the window as far as possible window and close the window as far as possible
trapping the Exhaust Nozzle (as shown below). trapping the Exhaust Nozzle (as shown below).
Fig.3
In the wall: we
recommend you to
insulate the section
of wall using suitable
insulation materials.
3
3
x 2
5
x 1 x 1
x 1