NordicTrack SL 705 NTC05940 User Manual page 6

5. Have another person hold the Console (4) near the
Handlebar (3).
Connect the Upper Wire Harness (42) to the wire har-
ness on the Console (4). Locate the two ground wires
that are connected with a screw to the Handlebar (3).
Connect the two ground wires to the two smallest wires
on the Console. Next, locate the pulse wire extending
from the Handlebar and connect it to the correspond-
ing wire on the Console.
Attach the Handlebar Cover (5) to the Handlebar (3)
with an M4 x 16mm Screw (57).
Carefully insert all excess wires into the Console (4).
Attach the Console to the metal plate on the Handlebar
(3) with four M4 x 16mm Screws (57). Be careful to
avoid pinching the wires.
6. Turn the Seat Post Knob (20) counterclockwise two or
three turns to loosen it. Next, pull the Knob, raise the
Seat Post (8) a few inches, and then release the Knob.
Move the Seat Post up and down slightly until the
pin on the Knob snaps into one of the holes in the
Seat Post. Then, turn the Knob clockwise until it is
tight.
Attach the Seat Bracket (7) to the Seat Post (8) with
two M8 x 25mm Patch Screws (59). Make sure that
the Seat Bracket is oriented so the slot is on the
indicated side.
7. Attach the Seat (9) to the Seat Carriage (11) with four
M8 Nylon Locknuts (63) and four M8 Split Washers
(55). Note: The Nylon Locknuts and Split Washers
may be pre-attached to the underside of the Seat.
Slide the Seat Carriage (11) into the Seat Bracket (7).
Move the Seat to the desired position. Insert the Seat
Knob (10) into the slot in the side of the Seat Bracket,
and tighten the Seat Knob into the Seat Carriage.
5
4
3
57
6
7
7
6
Do not pinch
the wires during
this step.
5
Ground
Wires
42
57
Pulse
Wire
59
7
Slot
8
20
9
11
10
55
63