Page 1
Model No. NTXC80181 QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction. If you have questions, or if parts are missing or damaged, we will guarantee complete satisfaction through direct assistance from our factory. TO AVOID UNNECESSARY...
Read all instructions before using this product. ICON assumes no responsibility for per- sonal injury or property damage sustained by or through the use of this product. SAVE THESE INSTRUCTIONS NordicTrack become caught on the ski exerciser. Always wear athletic shoes for foot protection.
EFORE EGIN Thank you for selecting the innovative NordicTrack CLASSIC PRO cross-country ski exerciser. Cross- country skiing is one of the most effective exercises for increasing cardiovascular fitness, building endurance, and toning the muscles. The NordicTrack PRO cross-country ski exerciser features ultra-smooth...
SSEMBLY Place all parts of the ski exerciser in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. Assembly requires only the included flat wrench tool. 1. Align the holes in the Leg Bracket (2) with the holes in the Front Frame (1).
Page 5
4. Lift the Upper body Arm (27) into position as shown. Be sure the Snap Buttons (40) are fully extended and locked into position on both sides of the Hip Pad Slide (42). 5. The Console (66) requires two “AA” batteries (not includ- ed).
OW TO DJUST THE HOW TO ADJUST THE RESISTANCE OF THE SKIS To vary the intensity of your exercise, the amount of leg resistance can easily be adjusted by moving the resistance clamp on the upright. CAUTION: Always dismount the ski exerciser before adjusting the resistance of the skis.
Page 7
DESCRIPTION OF THE CONSOLE The console has five independent displays to provide continuous exercise feedback. The displays are described below. • Time—This mode displays the amount of time that you have exercised. • Speed—This mode displays your pace, in miles per hour.
OW TO SE THE Arm Cord Handgrip Handlebar Resistance Clamp Resistance Strap START WITH THE LEG MOTION ONLY Note: See page 6 for steps 1, 2, and 3. 1. Set the leg resistance and adjust the elevation. Beginners may prefer to start with the ski exerciser in its lowest possible elevated position.
AINTENANCE Inspect and tighten all parts each time you use the ski exerciser. CLEANING THE SKI EXERCISER Wipe your ski exerciser with a clean, dry cloth after each workout to remove perspiration and dirt. Any household window cleaner may be used to clean the chrome and black metal surfaces after each use.
Page 10
9. Slide the resistance strap back onto the flywheel. Note: If the resistance strap is frayed on both sides, it may be necessary to replace it. See the back cover of this manual for information on how to order replacement parts. GENERAL LUBRICATION If the front and rear Rollers (15) begin to...
ROUBLE-SHOOTING Most ski exerciser problems can be solved by following the steps below. Find the problem that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department. PROBLEM: The console does not function properly. SOLUTION: a.
Page 12
b. Roughen the surface of the resistance pad with 100-grit sandpaper. Oil the leather resistance pad with one or two drops of light household oil. Spread the oil over the resistance pad. c. Oil the 3/8” washers and the thrust washer if needed. PROBLEM: The flywheel and/or the resistance strap offers no resistance.
ONDITIONING UIDELINES The following guidelines will help you to plan your exercise program. Remember that proper nutrition and adequate rest are essential for successful results. WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for individuals over the age of 35 or individuals with pre-existing health problems.
Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays). Please mention the following information when calling. • The MODEL NUMBER of the product (NTXC80181). • The NAME of the product (NordicTrack • The KEY NUMBER and DESCRIPTION of the part(s) from page 14 of this manual.