HYOSUNG GD250 Owner's Manual page 45

GD250-0000
5. Reinstall the engine oil drain plug ②
securely, but do not overtighten them.
❸
6. Loosen the engine oil filter ③ counter-
clockwise and remove it with a 30mm
socket wrench.
7. Wipe off the mounting surface on the
engine where the new engine oil filter will
be seated with a clean rag.
8. Smear a little engine oil around the
rubber gasket of the new engine oil filter.
Ⓑ
F
L
When replacing the engine oil filter, it is
highly recommended that you use a
genuine HYOSUNG oil filter designed
for your motorcycle, as other filters may
have different design and thread
specifications which could cause
engine damage or oil leaks.
9. Screw on the new engine oil filter by
hand until the filter gasket contacts the
mounting surface (a small resistance will
be felt).
And, tighten the new engine oil filter with
a 30mm socket wrench.
To tighten the engine oil filter properly, it
is important to accurately identify the
position at which the oil filter gasket first
contacts the mounting surface.
10. Pour the fresh engine oil through the
engine oil filler hole. Approximately 1,300
㎖ of the engine oil will be required.
Approximately 1,100 ㎖ of the engine
oil must be required when changing
the engine oil only without replacing
the engine oil filter.
In case of the engine oil being over
filled, the engine output will be reduced.
Be careful not to over fill the engine oil.
44
CAUTION
CAUTION
CAUTION
CAUTION